Commit 4edadfb9 authored by Roger Pueyo Centelles's avatar Roger Pueyo Centelles Committed by Adrian Schmutzler
Browse files

ath79: add support for Ubiquiti NanoStation Loco M (XW)



This commit adds support for the NanoStation Loco M2/M5 XW devices
on the ath79 target (support was long ago available on ar71xx).

Specifications:

 - AR9342 SoC @ 535 MHz
 - 64 MB RAM
 - 8 MB SPI flash
 - 1x 10/100 Mbps Ethernet, 24 Vdc PoE-in
 - AR8032 switch
 - 2T2R 5 GHz radio, 22 dBm
 - 13 dBi built-in antenna
 - POWER/LAN green LEDs
 - 4x RSSI LEDs (red, orange, green, green)
 - UART (115200 8N1) on PCB

Flashing via TFTP:

 - Use a pointy tool (e.g., pen cap, paper clip) and keep the reset
   button on the device or on the PoE supply pressed
 - Power on the device via PoE (keep reset button pressed)
 - Keep pressing until LEDs flash alternatively LED1+LED3 =>
   LED2+LED4 => LED1+LED3, etc.
 - Release reset button
 - The device starts a TFTP server at 192.168.1.20
 - Set a static IP on the computer (e.g., 192.168.1.21/24)
 - Upload via tftp the factory image:
   $ tftp 192.168.1.20
   tftp> bin
   tftp> trace
   tftp> put openwrt-ath79-generic-xxxxx-ubnt_nanostation-loco-m-xw-squashfs-factory.bin
Signed-off-by: default avatarRoger Pueyo Centelles <roger.pueyo@guifi.net>
(backported from commit 633c4304

)
Signed-off-by: default avatarAdrian Schmutzler <freifunk@adrianschmutzler.de>
parent cf118077
......@@ -201,6 +201,7 @@ tplink,tl-wr842n-v2)
ubnt,bullet-m|\
ubnt,bullet-m-xw|\
ubnt,nanostation-loco-m|\
ubnt,nanostation-loco-m-xw|\
ubnt,nanostation-m|\
ubnt,nanostation-m-xw|\
ubnt,picostation-m|\
......
......@@ -39,6 +39,7 @@ ath79_setup_interfaces()
ubnt,nanobeam-ac|\
ubnt,nanostation-ac-loco|\
ubnt,nanostation-loco-m|\
ubnt,nanostation-loco-m-xw|\
ubnt,picostation-m|\
ubnt,rocket-m|\
ubnt,unifiac-lite|\
......
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar9342_ubnt_xw.dtsi"
/ {
compatible = "ubnt,nanostation-loco-m-xw", "ubnt,xw", "qca,ar9342";
model = "Ubiquiti Nanostation Loco M (XW)";
};
&mdio0 {
status = "okay";
phy-mask = <0x1>;
phy1: ethernet-phy@1 {
reg = <1>;
phy-mode = "mii";
};
};
&eth0 {
status = "okay";
phy-handle = <&phy1>;
};
......@@ -125,6 +125,14 @@ define Device/ubnt_nanostation-loco-m
endef
TARGET_DEVICES += ubnt_nanostation-loco-m
define Device/ubnt_nanostation-loco-m-xw
$(Device/ubnt-xw)
DEVICE_TITLE := Ubiquiti Nanostation Loco M (XW)
DEVICE_PACKAGES += rssileds
SUPPORTED_DEVICES += loco-m-xw
endef
TARGET_DEVICES += ubnt_nanostation-loco-m-xw
define Device/ubnt_nanostation-m
$(Device/ubnt-xm)
DEVICE_TITLE := Ubiquiti Nanostation M
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment